Blower Mapro JDK-S-150 Membrane Blower 115W 230V

Description of the blower Mapro JDK-S-150 Membrane Blower 115W 230V

Mapro JDK-S-150 Membrane Blower 115W 230V replaces the old model EL-S

Operating principle of the blower Mapro Membrane Blower
The principle of operation of membrane blowers is based on electromagnetic oscillation.
The electromagnets, activated by the electric current, make a shaft oscillate which is the support of the magnet
An elastic membrane is attached to the ends of the shaft, which, due to the effect of the oscillation, causes the volume of a chamber to vary, of which the membrane forms a wall
In the chamber of the Mapro JDK-S-150, air can enter through a one-way suction valve during the expansion phase and exit the chamber through a second one-way valve that opens during the compression phase
Compressed air use is connected to the outlet of this second valve.

Advantages of the blower Mapro
The principle of electromagnetic oscillation is known for its excellent efficiency
In the Mapro JDK-S-150 the electrical energy is not dissipated by mechanical friction, but used directly for the compression action of the membranes.
Since there is no friction between the moving parts, there is no need for lubrication, and therefore the conveyed air is not polluted at all.
In addition to this, the major advantages of using membrane blowers are:
- Maximum simplicity of installation;
- long operating life (over 20,000 hours of continuous service);
- very low noise level;
- simple maintenance;
- compact and lightweight construction;
- low vibrations;
- flow with negligible pulsations.
- Areas of application
- aeration of wastewater in small treatment plants;
- oxygenation of aquariums;
- aeration of baths in the chemical industry;
- bubble massage;
- tank pressurization in the bottling industry;
- generation of air bubbles in decorative water columns.

Technical specifications of the blower Mapro JDK-S-150 Membrane Blower 115W 230V

Power: 115 W
Voltage: 230 V
Free mouth flow rate: 270 LT/MIN

Data Sheet Blower Mapro JDK-S-150