Logic Stop

Description Presscontrol Logic Stop:

Presscontrol Logic

Stop is an

electronic motor protector that stops the pump and protects it from dry running and overcurrent.
In order to function,Presscontrol Logic Stop must be plugged into the electrical supply line of the pump.
For this reason, the plug of the pump's power cord must be plugged into the appliance's outlet, and the appliance must be plugged into the outlet.
If there is no water in the suction line, Presscontrol Logic Stop stops the pump and protects it from running dry.
The fault is indicated by the red "Failure" LED flashing.
If a current absorption higher than 8 Ampere occurs, Presscontrol Logic Stop stops the pump protecting it from overcurrent.
The anomaly is indicated by the red LED on steady. To restore normal operation of the device and the system, simply press the red "Restart" button. In the event of a power failure, the device automatically resets itself a few seconds after the power returns.

Technical specifications Press

controlLogic Stop
Presscontrol Logic Stop
Single-phase line voltage: 115 Vac - 230 Vac
Acceptable voltage variations: +/- 10%
Frequency: 50 Hz
Current: min 3 A - max 8 A
Maximum power: 0.55 kW (0.75 HP) - 1.1 kW (1.5 HP)
Operating temperature: min 5°C - max 45°C
Maximum environmental temperature: 55°C


Data Sheet Logic Stop